QUICK REFERENCE − DECO 13A
en 300417 − 04/08 36
2.6 RUN A PROGRAM AT 5% FEEDRATE FORWARD
Actions Comments
Press CYCLE START in AUTO
1. Press CYCLE STOP
2. Hold down +. to advance at
5%. Release the key to stop.
2.7 EDIT TOOL WEAR OFFSET
Actions Comments
1. Press once / twice OFFSET
SETTING to open the
OFFSET page.
2. Tip in Axis No. over NC key-
board.
3. Press this softkey to search
axis: (AXISRH)
4. Modify offset as required.
Note:
Editing in μm (microns)
Editing X at Diameter.
5. Press this softkey: (INPUT+)
To Next Page
Loading...
