QUICK REFERENCE − DECO 13A
en 300417 − 04/08 14
1.8 G9XX MACROS
G900 Spindle ON
G901 Program sequence.
To be inserted once only at each program start
G902 Override limit
G903 Tool change (indexing)
G904 Workpiece cutting−off at constant surface speed
G910 Initialize (INIT.PGM) Initial cutoff
G911 Z1 Zero Offset (PIECE.PGM)
G912 Feeding (PIECE.PGM)
G913 Deburring + waste ejection from guidebush (END_BAR.PGM)
G914 Spindle feed for new bar insertion, initial cutoff
(NEW_BAR.PGM)
G915 Additional offset in Z3.
Resets to Part Zero acc. to Z1 position.
G916 Additional offset in Z4 for anticipated partpickoff
G917 Polygoning T25
G920 Test if part is withheld at end of cycle (INIT.PGM)
G921 Calculate part pickoff position (PIECE.PGM)
G923 Eject part from pickoff−spindle
G933 Threading cycle (tapping)
G977 Drilling / chip clearing cycle
To Next Page
Loading...
