QUICK REFERENCE − DECO 13A
en 300417 − 04/08 15
1.9 GLOBAL PART VARIABLES
#3000 Cutoff Tool No
(11,12,13,14,15,21,22,23,24,25).
#3001
Bar diameter
#3002 Initial cutoff feedrate (after RESET and new bar)
[mm/rev;inch/rev]
#3003
Positive part length
#3004
Feeding allowance for offset tool
#3005
Positive deburring shift
#3006 Guidebush type 0= fixed 1=rotating 2=Habegger
#3007 Open collet dwell [s]
#3008 Close collet dwell [s]
#3009
Part pickoff length
#3010
Pickoff−spindle collet geometry
#3011
Retract after part−pickoff
#3012
Pickoff−spindle approach distance
#3014
Z1 retract to eject waste
#3015
Z1 feed to insert new bar
#3016 S1 speed to feed next part [rpm]
#3017 Ejection method: 0 = Gripper
1 = Tray + Ejector
2 = Gripper + Ejector
#3018
Part gripping length
#3019 Longueur de barre utilisée
= each time [mm] [inch]
To Next Page
Loading...
