tornos MULTIDECO Series - Unpacking; Cleaning; Removal of Rust-Proofing

INSTALLATION – MULTIDECO 26/6 – MULTIDECO 32/6i
300381 en – 06/02 Chap. 2.3.1 /2
2.2 UNPACKING
Pull out nails from the cover and then from the walls of the case. Remove the
vacuum–packing plastic.
Remove the wooden wedges and ropes that hold various items.
⇒ Note:
Refer to the transport document
– 300379 for M
ULTIDECO 26/6 or
– 300369 for M
ULTIDECO 32/6i
supplied with all the machine documentation.
∆ Caution!
Unlocking must not be performed until the machine has been set in
position.
2.3 CLEANING
2.3.1 Removal of rust–proofing
⇒ Note:
The rust inhibitor applied depends on the particular destination.
∆ Attention!
Cleaning must only be performed in well–ventilated areas
(inhalation of toxic vapours).
Action Notes
Clean carefully all the parts cov-
ered with anti–rust coating using
cloths soaked in benzine or paraf-
fin
∆ Caution!
Cause no damage or misadjust-
ment.
∆ Avoid using compressed air and
products which may damage
synthetic materials.