Toro 04591 - Understanding the Infocenter Dialog Messages; Tilting the Steering Wheel

Note: When you install the 3-Wheel-Drive Kit, the kit
is automatically enabled.
Setting the Battery-Reserve
Capacity
Navigate to the B ATT . R ESERVE option to set the
amount of distance needed to transport the machine
to the shop. This allows you to have enough battery
power (when the battery level becomes too low) to
transport the machine to the shop for recharging; refer
to Monitoring the Battery-System Charge Level ( page
33 ) .
Note: Y ou can adjust the distance from 0.8 km (0.5
mi) to 8 km (5 mi) in 0.8 km (0.5 mi) increments.
Understanding the
InfoCenter Dialog
Messages
When the machine is being calibrated, dialog
messages appear in the InfoCenter . These messages
are intended to instruct you through the calibration
process.
Refer to the following table for a list of each dialog
message:
Dialog Messages
Message
Number
InfoCenter Message T ext
1 Return pedal to neutral
4
Move pedal to max forward and hold
5
Max forward calibration passed
9
Max forward calibration failed. V oltage out of spec
13 Move pedal to max reverse and hold
14 Max reverse calibration passed
16
Max reverse calibration failed. V oltage out of spec
17
Calibration failed. Pedal position unknown
18
Return pedal to neutral. Continue?
100
Calibration is engaged
101
Calibration is complete
102
Cycle the key switch
1 10
Inhibit calibration. Component not responding
1 1 1
Inhibit calibration. Component not ready
1 12 Inhibit calibration. Fault active
1 13 Inhibit calibration. Not in seat
1 14 Inhibit calibration. Not in neutral
1 15 Inhibit calibration. In neutral
Dialog Messages (cont'd.)
1 16 Inhibit calibration. Parking brake is engaged
300 Return pedal to neutral
301
Center steering wheel. Continue?
302
Manually center rear wheel. Continue?
303
Steer rear wheel max left. Continue?
304
Steer rear wheel max right. Continue?
305
Rear wheel center out of range
306
Rear wheel angle out of range
400
Caution: Machine must be on jack stands.
Continue?
401
Inhibit calibration. Contactor open
402 Inhibit calibration. Pedal in Neutral
403 Return pedal to neutral
404
W ait for wheels to stop
405
Move pedal to max forward and hold
406
Calibration active. Hold pedal
500
Lift/Lower extend active
501
Lift/Lower retract active
502 Move joystick to lower position
503 Move joystick to raise position
504
Is the cutting unit installed? Continue?
1 100 T raction diagnostic messages enabled
1 101
Steering diagnostic messages enabled
T ilting the Steering Wheel
Y ou can tilt the steering wheel to a comfortable
operating position.
1. Loosen the bolts ( Figure 26 ) that secure the
steering-wheel assembly to the steering arm.
28