g236365
Figure 18
1. Parking brake 2. Brake pedal
Parking Brake
Use the parking brake ( Figure 18 ) to prevent the
machine from moving. T o engage the parking brake,
push down on the brake pedal and press the top
forward to latch. T o release the parking brake, press
the brake pedal until the parking-brake latch retracts.
InfoCenter
Using the InfoCenter LCD Display
The InfoCenter LCD display shows information
about your machine, such as the operating status,
various diagnostics, and other information about the
machine ( Figure 22 ). There is a splash screen, main
information screen, cutting unit (CU) motor information
screen, and traction information screen.
• Splash screen : shows current machine
information for a few seconds after you move the
key to the O N position.
• Main information screen ( Figure 19 ): shows
current machine information while the key is in the
O N position. This screen shows the battery-system
charge level and the amperage.
g292768
Figure 19
1. Battery-system amperage 2. Battery-system charge
level
• CU motor information screen ( Figure 20 ):
shows the speed and current of each cutting-unit
motor .
g292767
Figure 20
1. Front left cutting motor 3. Center cutting-unit motor
2. Front right cutting-unit
motor
• T raction information screen ( Figure 21 ):
shows the current steering angle and the
amperage allotted to each traction motor .
g292769
Figure 21
1. Amperage—Front, left
traction motor
3. Amperage—Center
traction motor
2. Amperage—Front, right
traction motor
4. Steering angle
• Main menu : refer to Understanding the InfoCenter
Menu Items ( page 21 ) .
Note: Protected under Protected
Menus—accessible only by entering PIN;
refer to Accessing Protected Menus ( page 22 ) .
Y ou can switch between the main, CU motor , and
traction information screens by pressing the right
button and then selecting the appropriate directional
arrow .
19
To Next Page
Loading...
