Toro 04591 - Maintenance; Maintenance Safety; Recommended Maintenance Schedule(S)

Maintenance
W ARNING
Modifying the original machine, parts,
and/or accessories may alter the warranty ,
controllability , and safety of the machine.
Making unauthorized modications to the
original machine and/or not using genuine
T oro parts could lead to serious injury or
death.
• Do not make unauthorized modications to
the machine, parts, and/or accessories.
• Use only genuine T oro parts.
Maintenance Safety
• Before you leave the operator ’ s position, do the
following:
– Park the machine on a level surface.
– Move the function-control switch to the
N EUTRAL position.
– Ensure that the cutting units are disengaged
and lower them to the ground.
– Engage the parking brake.
– Shut of f the machine and remove the key .
– W ait for all movement to stop.
• Allow machine components to cool before
performing maintenance.
• Only allow a qualied repair person to service the
machine.
• Disconnect the main-power connectors before
performing maintenance.
• If possible, do not perform maintenance while the
machine is running. Keep away from moving parts.
• Support the machine with jack stands whenever
you work under the machine.
• Carefully release pressure from components with
stored energy .
• Keep all parts of the machine in good working
condition and all hardware tightened.
• Replace all worn or damaged decals.
• T o ensure safe, optimal performance of the
machine, use only genuine T oro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty .
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the rst 8 hours
• T orque the wheel nuts.
• Change the traction-motor-gearbox uid.
Before each use or daily
• Inspect the seat belt(s) for wear , cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly .
• Check the safety-interlock system.
• Inspect and cleanup after mowing.
• Check the tire pressure.
• Check the reel-to-bedknife contact.
• W ash the machine (do not use high-pressure water).
Every 50 hours
• Check the battery cable connections.
Every 200 hours
• T orque the wheel nuts.
Every 800 hours
• Change the traction-motor-gearbox uid.
40