Inspecting and Cleaning
after Mowing
After mowing, thoroughly wash the machine with
a garden hose without a nozzle so that excessive
water pressure does not contaminate and damage the
seals, bearings, and electronics. Do not wash the
electrical connections with water .
Important: Do not use brackish or reclaimed
water to clean the machine.
Important: Do not use power-washing equipment
to wash the machine. Power-washing equipment
may damage the electrical system, loosen
important decals, or wash away necessary grease
at friction points. It may force water under seals,
contaminating oil or grease contained housings.
A void excessive use of water near the control
panel and batteries.
Inspect the cutting units for sharpness after you clean
the machine.
Hauling the Machine
• Use care when loading or unloading the machine
into a trailer or a truck.
• Use a full-width ramp for loading the machine into
a trailer or a truck.
• T ie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine ( Figure 29 ).
g389181
Figure 29
1. Rear tie-down loop
2. T ie-down loop (each side
of the machine)
35
To Next Page
Loading...
