Toro 34230 - Operating the Spreader

g305692
Figure23
SpreaderFirmwareScreen
g305693
Figure24
SpreaderHoursScreen
DefaultSpreaderScreen
Thedefaultscreenappearsaftertheinitialstart-up
screens.
g305459
Figure25
Spreaderdefaultscreen
1.Defaultscreen—impellermotorisshutoff
SpreaderMotorScreen
Thespreadermotorscreenappearsiftheimpeller
controlswitchistapped.
Note:Ifthemotorisrunforeightseconds,thedefault
screendisplays.
g305328
Figure26
SpreaderMotorScreen
UsingtheImpellerControlSwitch
g305645
Figure27
1.ImpellerControlSwitch2.Spreaderandinformation
display
Usetheimpellercontrolswitch(Figure27)tostart
theelectricmotorthatdrivestheimpeller,adjustthe
impeller-motorspeed,andshutofftheimpellermotor.
•Tapthetopoftheimpellercontrolswitchtorun
theimpellermotor.
•Tapthetopoftheimpellercontrolswitchtoraise
theimpellerrotationspeed.
•Tapthebottomoftheimpellercontrolswitchto
lowertheimpellerrotationspeed.
•Pushthebottomoftheimpellercontrolswitchfor
1-secondtoshutofftheimpellermotor.
BeforeOperatingtheSpreader
Beforeyoustartusingthespreader,calibratethe
spreaderforthematerialthatyouwilldisperse;refer
toCalibratingtheSpreader(page27).
Important:Priortollingthehopper,verifythat
youhavesettheproperspreader-applicationrate.
26