Figure 15
1. PTO-Off 4. Throttle lever
2. Choke-On
5. Fast
3. Choke-Off 6. Slow
5. Mo v e throttle lev er to the fast position ( Figure 15 ).
6. T ur n the ignition k ey and hold it in the star t
position ( Figure 16 ). W hen the engine star ts ,
release the k ey .
Important: If the engine does not star t
after 10 seconds of contin uous cranking ,
tur n the ignition k ey to of f and let the
star ter motor cool f or 60 seconds; r efer to
T r oubleshooting T r oubleshooting , pa ge 39 .
7. After the engine star ts , mo v e the c hok e lev er to off
( Figure 15 ). If the engine stalls or hesitates , mo v e
the c hok e lev er bac k to on for a few seconds . T hen
mo v e the throttle lev er to desired setting . R e peat
this as required.
Figure 16
1. Off
3. Run
2. Lights
4. Start
Stopping the Engine
1. Push the PTO (po w er tak e off) to off ( Figure 15 ).
2. Mo v e the throttle lev er betw een half and full
throttle ( Figure 15 ).
3. T ur n the ignition k ey to off ( Figure 16 ).
Operating the Power Take
Off (PTO)
T he po w er tak e off (PTO) eng ag es and diseng ag es
po w er to the electric clutc h.
W hile the ignition k ey is in r un or lights position and
the po w er tak e off (PTO) is eng ag ed on, the PTO light,
in the Indicator Module , will be on. W hen this light is
on it is a reminder; the star ter will not crank and to
tur n the off PTO before g etting off .
Engaging the Power Take Off (PTO)
Pull the po w er tak e off (PTO) to on ( Figure 17 ).
Figure 17
1. Off-disengaged 2. On-engaged
Disengaging the Power Take Off
(PTO)
Push the po w er tak e off (PTO) to off ( Figure 17 ).
The Safety Interlock System
If safety inter lock s witches ar e disconnected
or dama ged the machine could operate
unexpectedl y causing per sonal injur y .
• Do not tamper with the inter lock s witches.
• Check the operation of the inter lock s witches
dail y and r eplace an y dama ged s witches
bef or e operating the machine.
21
To Next Page