HYDRAULIC SYSTEM
5-8 Toro Z Master G3 3000/5000/6000 Series Service Manual
5
35. Remove the 2 nuts from the bolts securing the UHT
to the cradle (Fig. 291).
Caution: The UHT weighs approximately 80 lbs.
(36.29kg).
Fig. 289 PICT-8619a
34. Lower the UHT/cradle assembly from the frame
by lowering the oor jack. Take care that the brake
cables and UHT fan are clear of the frame (Fig.
290).
Note: Ensure the control arm shaft clears the frame
and the control arm linkage doesn’t get
caught between the frame and the UHT as it is
being lowered.
Fig. 290 PICT-8620
Fig. 291 PICT-8623a
36. Remove the UHT from the cradle (Fig. 292).
Fig. 292 PICT-8624
33. On the side of the machine being serviced, remove
the 2 bolts securing the UHT to the frame (Fig. 289).
To Next Page
Loading...
