Toro 74954 - Wheel Hub Slotted Nut Installation

HYDRAULIC SYSTEM
5-32 Toro Z Master G3 3000/5000/6000 Series Service Manual
5
19. Disengage the parking brake. Rotate the drive wheel
release handle to the released position. Turn the
wheel hub by hand in both directions relative to the
caliper; no drag of the caliper pad on the wheel hub
is desired.
20. After adjusting the brake, cycle the brake handle a
minimum of six times to allow the cable to seat into
the sheath and mounting tabs. Recheck the spring
length.
21. Rotate the drive wheel release handle to the
operating position.
Fig. 369 DSCN-4315a
22. Installing the wheel Hub slotted nut
• Style A (black nish): (Fig. 370)
Torque the slotted nut to 211 - 260 ft-lbs. (286 - 352 Nm).
Note: Do Not use anti-seize on wheel hub.
Fig. 370 g. 67 G011815_A
A. Style A (black nish) B. 0.03” (0.76mm)
• Style B (yellow zinc): (Fig. 371)
C. Style B (yellow zinc) B. 0.24” (6mm)
Fig. 371 g. 67 G011815_B
18. Hold the end of the threaded rod with a tool and
adjust the lock nut until the spring length is between
1-1/2” and 1-9/16” (3.8 and 4.0cm) (Fig. 369).
Note: DO NOT allow the cable to turn when the nut
is being turned.
C
D
A
B
Wheel Hub Slotted Nut Installation