Toro 74954 - Right Park Brake Cable Removal (2012 & Later)

CHASSIS
3-41Toro Z Master G3 3000/5000/6000 Series Service Manual
3
Right Park Brake Cable Removal (2012 &
Later)
1. Raise the rear end of the unit and install jack stands
under the tie down loop on the frame. Remove the
RH and LH wheels from the unit (Fig. 148).
Fig. 148 DSCN-4311a
2. Disengage the park brake lever.
3. Remove the e-ring, washer, and brake pin from the
L-Bracket (Fig. 149).
Fig. 149 DSCN-4364a
Fig. 150 DSCN-4366a
4. Hold the end of the threaded rod with a tool and with
a socket wrench remove the lock nut and washer
from the end of the cable (Fig. 150). Remove the
washer, spring and the L-Bracket.
5. Remove the e-ring from the groove in the cable end
and cable anchor located on the transmission (Fig.
151).
Fig. 151 DSCN-4368