Toro 74954 - Motion Control Assembly Installation

CHASSIS
3-58 Toro Z Master G3 3000/5000/6000 Series Service Manual
3
Motion Control Assembly Installation
1. Install 4 new ange bushings in the LH motion
control (Fig. 204).
Fig. 204 DSCN-4487a
2. Install motion control lever in the LH motion control
(Fig. 205).
Fig. 205 DSCN-4488a
3. Install at washer on motion control lever (Fig. 206).
Fig. 206 DSCN-4489a
4. Install the two spring washers with the crown side of
the washers facing out (Fig. 207).
Fig. 207 DSCN-4490