Toro 74954 - Electric PTO Clutch Installation

MOWER DECKS
6-32 Toro Z Master G3 3000/5000/6000 Series Service Manual
6
Electric PTO Clutch Installation
A. Bolt C. Washer
B. Spring Washer (2)
3. Plug the clutch wire plug into the electric PTO clutch
(Fig. 475).
Fig. 473 DSCN-0060a
2. Install the electric PTO clutch on the crankshaft;
make sure the slot on the clutch ts on the clutch
anchor. Using the bolt, spring washers, and washer,
torque the clutch bolt to 55 ± 6 ft-lbs. (74.6 ± 8 Nm)
(Fig. 474).
Fig. 474 DSCN-0061a
Fig. 475 DSCN-0028a
4. Using a 3/8” breaker bar, install the mower idler arm
assembly and relieve the tension on the idler arm
assembly. Install the mower drive belt around the
electric PTO clutch (Fig. 476).
Fig. 476 DSCN-0020a
1. Prepare the clutch bolt, spring washers (with crown
of the washers facing the bolt head), and washer
(Fig. 473).
A
B
C
5. Install the oor pan.
6. Remove the jack stands and lower the machine to
the ground.
7. Install the battery negative cable to the battery.