Toro 74954 - Page 156

MOWER DECKS
6-19Toro Z Master G3 3000/5000/6000 Series Service Manual
6
6. Using a hammer and driver with a square edge,
drive the bearing out of the spindle housing (Fig.
441).
5. Remove the top oil seal (Fig. 440).
Fig. 440 DSCN-0092a
Fig. 441 DSCN-0093
8. Using a hammer and driver with a square edge,
drive the bottom bearing and seal out of the spindle
housing (Fig. 443).
7. Remove the spacer from the spindle housing (Fig.
442).
Fig. 442 DSCN-0094a
Fig. 443 DSCN-0096a