Toro 74954 - Page 159

MOWER DECKS
6-22 Toro Z Master G3 3000/5000/6000 Series Service Manual
6
5. Press seal into the bottom of the spindle housing
(Fig. 450).
Fig. 450 DSCN-0115a
6. Install spindle shaft in the spindle housing (Fig. 451).
Fig. 451 DSCN-0122a
8. Install the washer and lock nut retaining the spindle
hub to the spindle shaft. Torque the nut to 120 ± 5
ft-lbs. (162.7 ± 6.8 Nm) (Fig. 453).
Fig. 452 DSCN-0123a
Fig. 453 DSCN-0125
7. Install the spindle hub on the spindle shaft (Fig.
452).
9. Install the pulley on the spindle hub and torque the 3
ange nuts to 37 ± 4 ft-lbs. (50 ± 5.4 Nm).
10. Grease the spindle assembly using No. 2 grease.