MOWER DECKS
6-26 Toro Z Master G3 3000/5000/6000 Series Service Manual
6
16. On both sides of the deck, measure from the level
surface to the back tip of the blade (Position B). The
measurement should read 3-1/4” (8.3cm) (Fig 461).
15. Tighten the two bolts at the bottom of the height-of-
cut plate (Fig. 460). Torque to 27-33 ft-lbs. (37-45
Nm).
Note: In most conditions, the back blade tip should
be adjusted 1/4” (6.4mm) higher than the
front.
Fig. 460 g. 96 G017029
A. Bolts at the bottom of the height-of-cut plate
A
Fig. 461 g. 93 G009196
1. 3” (7.6cm) at A is 3. Measure here from
correct the blade tip to hard
2. 3-1/4” (8.3cm) at B surface
is correct 4. Measure at A & B on
both sides
1
2
4
3
To Next Page
Loading...
