Toro 74954 - Page 51

CHASSIS
3-30 Toro Z Master G3 3000/5000/6000 Series Service Manual
3
3. Install a cotter pin through the clevis pin (Fig. 109).
Fig. 109 PICT-9101a
4. Install the rubber seal over the end of the brake snap
tting (Fig. 110).
Fig. 110 PICT-9103a
5. Route the brake cable through the side hole in the
frame and down through the hole in the cradle (Fig.
111).
Fig. 111 PICT-9105a
6. Route the brake cable from the hole in the cradle,
back to the slot of the cradle (Fig. 112).
Fig. 112 cables routing #4
A. Right side brake C. Left side brake
assembly assembly
B. Cradle D. Retainer (5)
E. Hole (2)
A
B
E
E
C
D
D