What to do if my Toro 74991 is vibrating abnormally?
If your Toro Lawn Mower is experiencing abnormal vibration, start by checking the cutting blades. If any blade is bent or unbalanced, install new ones. Ensure the blade mounting bolt and engine mounting bolts are properly tightened. Also, inspect the engine pulley, idler pulley, or blade pulley for looseness and tighten the appropriate pulley.
What to do if my Toro 74991 Lawn Mower won't drive?
If your Toro Lawn Mower isn't driving, check these items: * Ensure the bypass valves are tightly closed. * Change the pump belt if it is worn, loose, or broken. * Change the pump belt if it is off a pulley. * Replace the idler spring if it is broken or missing. * Add hydraulic oil to the reservoirs or allow it to cool down if the hydraulic oil level is low or too hot.
Why won't my Toro 74991 Lawn Mower starter crank?
If the starter on your Toro Lawn Mower doesn't crank, there are several possible reasons. First, ensure the blade control switch (PTO) is disengaged and the parking brake is set. Also, make sure the drive levers are in the neutral lock position and that you are seated on the seat. If these aren't the problem, check if the battery is dead and charge it if necessary. Inspect the electrical connections for corrosion or looseness, and replace the fuse if it's blown.
What to do if the clutch does not engage on my Toro 74991?
If the clutch does not engage on your Toro Lawn Mower, start by replacing the fuse if it is blown. Check the coil resistance, battery charge, charging system, and wiring connections, and replace components if necessary. Also, check the coil and replace the clutch if it is damaged. Repair or replace the clutch lead wire or electrical system if there is inadequate current supply, and clean the connector contacts. Finally, remove the shim or replace the clutch if the rotor/armature air gap is too large.
What to do if the blades don't rotate on my Toro 74991 Lawn Mower?
If the blades on your Toro Lawn Mower do not rotate, install a new deck belt, install the mower deck pulley and check the idler pulley, idler arm, and spring for correct position and function, check the belt tension or install a new belt, or replace the spring.
Why aren't the blades rotating on my Toro 74991?
If the blades on your Toro Lawn Mower aren't rotating, check the following: replace the deck belt if it is damaged, worn, loose, or broken. Install the mower belt on the deck pulley and check the idler pulley, idler arm, and spring for correct position and function. Check the belt tension or install a new belt if the pump drive belt is worn, loose, or broken. Replace the spring if the idler spring is broken or missing.
Why does my Toro 74991 Lawn Mower pull to the left or right?
If your mower pulls to one side, the tracking may need adjustment, or the tire pressure in the drive tires may not be correct. Adjust the tracking and the tire pressure in the drive tires.
What to do if my Toro 74991 Lawn Mower machine vibrates abnormally?
Abnormal vibrations in your Toro Lawn Mower can stem from several issues. Start by checking the cutting blades for bending or imbalance and install new cutting blade(s) if necessary. Ensure the blade mounting bolt and engine mounting bolts are tightened. Also, inspect the engine pulley, idler pulley, or blade pulley for looseness and tighten the appropriate pulley.
What causes the clutch not to engage on my Toro 74991 Lawn Mower?
If the clutch does not engage on your Toro Lawn Mower, replace the fuse. Check the coil resistance, battery charge, charging system, and wiring connections, and replace components if necessary. Check the coil resistance, battery charge, charging system, and wiring connections and replace parts if necessary if there is low voltage supply at the clutch. Replace the clutch if the coil is damaged. Repair or replace the clutch lead wire or electrical system, and clean the connector contacts if there is inadequate current supply. Remove the shim or replace the clutch if the rotor/armature air gap is too large.
What to do if my Toro 74991 Lawn Mower engine does not start?
If your Toro Lawn Mower engine doesn't start, starts hard, or fails to keep running, several factors could be at play. First, ensure the fuel tank isn't empty and the fuel-shutoff valve is open. Check that the oil level in the crankcase is sufficient and the throttle is positioned midway between the SLOW and FAST settings. Also, a dirty fuel filter or air cleaner can cause issues, so replace or clean them as needed. Inspect the spark plug, adjusting or replacing it if it's fouled or improperly gapped, and verify the spark-plug wire is securely connected. Finally, check the seat-switch indicator, replacing the seat if necessary.
General| Cutting Width | 22 inches |
|---|---|
| Start Type | Recoil |
| Drive Type | Self-Propelled |
| Starting System | Recoil |
| Deck Material | Steel |
| Oil Capacity | 20 oz |
| Cutting Height | 1 inch to 4 inches |
| Mulch, Bag, Side Discharge | Mulch, Bag, Side Discharge |
| Wheel Size | 8 in (20.3 cm) Front / 11 in (27.9 cm) Rear |
To Next Page
