Toro Diesel Z Master - Page 100

HYDRAULIC SYSTEM
4-13Z580/Z593/Z595 Diesel Service Manual
4
23. Position the left hand control rod ball joint to the
pump control arm. Install a bolt, washer and nut
securing the left hand control rod assembly to the
pump control arm (Fig. 284).
Note: The washer is installed between the ball joint
and the control arm.
25. Apply anti-seize compound onto the pump input
shaft (Fig. 286).
24. Position the right hand control rod ball joint to the
pump control arm. Install a bolt, washer and nut
securing the right hand control rod assembly to the
pump control arm (Fig. 285).
Note: The washer is installed between the ball joint
and the control arm.
Fig 284 PICT-3196
Fig 286 PICT-3340a
Fig 285 PICT-3195a
26. Install the key into the pump shaft keyway (Fig. 287).
Fig 287 PICT-3341