HYDRAULIC SYSTEM
4-23Z580/Z593/Z595 Diesel Service Manual
4
10. Apply the parking brake.
11. Install a castle nut onto the wheel motor shaft.
Torque the castle nut to 125 ft-lbs (170 Nm) (Fig.
319).
Note: If more than two threads are showing remove
nut and install washer between hub and nut
and then:
a. Torque the slotted nut to 125 ft-lbs. (170 Nm)
(Fig. 321).
b. If necessary, tighten the nut until the next set of
slots line up with the hole in the shaft (Fig. 321).
Fig 319 PICT-3385
Fig 321 fi g. 48 G001051 a
12. Check the distance from bottom of the slot in the nut
to the inside edge of the hole. Two threads or less
should be showing (Fig. 320).
A. Slotted nut C. Hole in threaded shaft
B. Two threads or less D. Washer (if needed)
showing
A. Slotted nut C. Hole in threaded shaft
B. Two threads or less
showing
Fig 320 fi g. 48 G001051 b
A
C
B
AD
C
B
To Next Page
Loading...
