9
Schedule Setup
Schedule Type Selection
e EVOLUTION
®
AG controller allows for exible watering by giving you three schedule types: Weekday, Interval, and Looping.
Weekday is the default scheduling type, and allows you to select individual days of the week to irrigate. Interval scheduling enables you to
select the delay between irrigations (e.g. every 3 days). Looping schedule will operate every day during the specied start and end time (e.g.
start the looping at 8am and stop at 5pm). While looping, watering will cycle through each valve on the schedule, followed by an optional
delay, and then start the cycle over again until the scheduled stop time. e default schedule type is Weekday.
Note: At any point, you can return to the previous menu by pressing the Left button or return to the main screen by
pressing the
HOME button.
Step 1 – Press the SCHEDULES button. Use the Up or Down arrows to select the Schedule you want to set/edit and
press SELECT .
Step 2 – While in the TYPE menu, use the Up or Down arrows to select the schedule type. Select either WEEKDAY,
INTERVAL, OR LOOPING.
SCHEDULE
SCHEDULE A
SCHEDULE B
SCHEDULE A
TYPE WEEKDAY
WATER DAYS
SCHEDULE STARTS
VALVE RUNTIME
Step 3 – Press SELECT to save the changes and return to the SCHEDULES menu.
Water Days Setup
Step 1 – Press the SCHEDULES button. If multiple schedules are enabled, use the Up or Down arrows to select the
Schedule you want to set/edit and press SELECT . See ADVANCED/SCHEDULE DETAILS section to enable multiple
schedules.
Step 2 – Use the Up or Down arrows to select WATER DAYS menu and press SELECT .
Step 3a – e WATER DAYS menu is dierent for each of the 3 schedule types. Select your desired watering days. Follow Step 3a, 3b, or
3c, depending on the Schedule Type you selected.
Water Days Setup for Weekday Schedule
Use the Left or Right arrows to navigate within the days of the week. Use the Up or Down arrows to activate
or turn o the day for watering. Repeat for all days of the week. Press SELECT when nished.
FP1 and FP2 stand for Fertilizer Pump 1, and Fertilizer Pump 2. Setup for Fertilizer Pumps is optional; to setup Fertilizer
Pumps, see Programming Fertigation section of this manual.
SCHEDULE A
TYPE WEEKDAY
WATER DAYS
SCHEDULE STARTS
VALVE RUNTIME
SCHEDULE A
WATER S M T W T F S
FP1
- - - - - -
FP2
- - - - - -
TODAY IS SATURDAY
e Weekday Schedule type allows the selection of individual days of the week for the fertilizer pumps to operate.
(Fertilizer pumps will operate every watering day with the Interval Schedule type, and will not operate at all with the Looping
Schedule type). e default fertilizer pump setting is NO for each day, designated by . To enable the fertilizer schedule for
each fertilizer pump (FP1 & FP2) for a specic day, use the Left or Right arrows to navigate to that day, and press
SELECT . A check mark will appear to indicate that the fertilizer pump selected will operate that day. FP1 and FP2 can
be operated together, or independently.
To Next Page
Loading...
Need help?
General
