Greensmaster Flex 1800/1820/2100/2120 Belt Driven Groomer (Optional)Page 8 − 21
The groomer RH drive plate assembly incorporates the
idler system for tensioning the groomer drive belt. The
idler system uses a spring to maintain proper belt ten-
sion.
Removal
1. Position machine on a clean and level surface with
engine stopped. Engage parking brake.
2. Remove groomer belt cover, drive belt and drive
pulley from groomer drive side of mower (see Grooming
Reel Removal in this section).
3. Using Figures 24 and 25 as guides, remove idler
bracket, idler pulley and/or idler bearings as needed.
Installation
1. Assemble components using Figures 24 and 25 as
guides.
NOTE: When properly installed, the idler pulley should
move freely from side to side on the idler bracket pin.
2. Install drive pulley, drive belt and belt cover to right
side of mower (see Grooming Reel Installation in this
section).
3. Check and adjust grooming reel height and mower
height−of−cut settings.
1. Drive pulley
2. Idler pulley assembly
3. Driven pulley
4. RH drive plate assy
5. Groomer drive belt
Figure 25
1
2
4
3
5
Groomer
To Next Page
Loading...
