Toro Greensmaster TriFlex 3400 Series - Installing and Removing the Cutting Units; Installing the Cutting Units

InstallingandRemoving
theCuttingUnits
InstallingtheCuttingUnits
1.Liftuponthefootrestandswingitopen,allowing
accesstothecentercuttingunitposition(Figure
31).
CAUTION
Thefootrestcanpinchngersifitfalls
intotheclosedposition.
Keepyourngersclearoftheareawhere
thefootrestseatswhileitisopen.
g014602
Figure31
1.Footrest—closed2.Footrest—open
2.Positionthecuttingunitunderthecenter
suspensionarm.
3.Withthelatchesonthesuspension-armbar
pointingup(i.e.,open)(Figure32),pushthe
suspensionarmdownsothatthebartsover
thebaracrossthetopofthecuttingunit(Figure
33).
g014609
Figure32
1.Latch—closedposition3.Latch—openposition
2.Suspension-armbar
g014611
Figure33
1.Suspension-armbar2.Cutting-unitbar
4.Closethelatchesdownandaroundthe
cutting-unitbarandlocktheminplace(Figure
32).
Note:A“click”canbeheardandfeltwhenthe
latchesareproperlylockedinplace.
5.Coatthesplineshaftofthecuttingunitmotor
withcleangrease(Figure34).
6.Insertthemotorintotheleftsideofthecutting
unit(asviewedfromtheoperator'sposition)and
pullthemotorretainingbaronthecuttingunit
towardthemotoruntilyouhearanaudible“click”
frombothsidesofthemotor(Figure34).
29