The engine is shipped with 3.8 qt (3.6 l) of oil in the
crankcase; however, level of oil must be checked
before and after the engine is first started.
Position machine on a level surface.
Open the hood.
Remove dipstick and wipe it with a clean rag. Insert
dipstick into the tube and make sure it is seated fully.
Remove dipstick and check level of oil (Fig. 11). If oil
level is low, add enough oil to raise level to FULL mark
on dipstick. Do not overfill (Fig. 12).
&$0-"
*$&*" +&( !&,./& '
*$&*" +&( #&(/"-
&( !-&* ,(0$
&$0-"
*$&*" +&( #&((
+/" If level of oil is at the ADD mark on the dipstick,
add 1 pint (0.47 l) of oil and recheck level. Do not
overfill.
The engine uses any highĆquality 10W30
detergent oil having the American Petroleum Institute
Ċ API Ċ"service classification" CD.
%" ' ("1"( +# +&( "1"-3 +,"-/&*$
%+0-. +- !&(3 %*$" +&( #/"- "1"-3 %+0-. +#
+,"-/&+*
Insert dipstick into tube.
Clean debris off screen and front of radiator daily
(Fig. 13), hourly if conditions are extremely dusty and
dirty; refer to Cleaning Radiator and Screen Section.
&$0-"
!&/+-
!&/+- . -""*
-""* %**"(
The cooling system is filled with a 50/50 solution of
water and permanent ethylene glycol antiĆfreeze.
Check level of coolant at beginning of each day
(Fig. 14) before starting the engine. Capacity of cooling
system is approximately 6 quarts (5.7 l).
Carefully remove radiator cap and the expansion
tank cap.
# "*$&*" %. ""* -0**&*$ ,-"..0-&4"! %+/
++(*/ * ". ," 2%"* -!&/+- , &. -"5
)+1"! *! 0." 0-*.
To Next Page
Loading...
