*(30&
", -321
!
&'.0& 5&+%*-( .- 2)& ,"$)*-&
%*1$.--&$2 (0.3-% $"#+& '0., 2)& #"22&06 2.
/0&4&-2 %","(& 2. 2)& &+&$20*$"+ 1612&,
.2& Check battery condition weekly or after every 50
hours of operation. Keep terminals and entire battery
case clean because a dirty battery will slowly
discharge. To clean the battery wash the entire case
with solution of baking soda and water. Rinse with clear
water. Coat the battery posts and cable connector with
Grafo 112X (SkinĆover) grease, Toro Part No. 505Ć47 or
petroleum jelly to prevent corrosion.
Prevent corrosion of wiring terminals by applying Grafo
112X (SkinĆover) grease, Toro Part No. 505Ć47, to the
inside of all harness connectors whenever the harness
is replaced.
Whenever working with the electrical system, always
disconnect battery cables, negative (-) cable first, to
prevent possible wiring damage from shortĆouts.
Fuses are accessible under seat plate (Fig. 43).
*(30&
$$&11.0*&1 '31& ",/
"'&26 15*2$)&1 '31& ",/
"*- '31& ",/
/"0& '31& ",/
To Next Page
Loading...
