Toro groundsmaster 455-D - Page 137

12. Remove quad-ring seal from seal gland bushing.
13. Use a thin blade screwdriver to pry dust seal from
se
al gland bushing. Do not damage bushing.
Figure 39
14. Remove 2 bearing races and the needle thrust
bearing from spool and sleeve assembly.
Figure 40
15. Remove spool and sleeve assembly from 14 hole
end of housing.
IMPORTANT: Do not bind spool and sleeve in hous-
ing. Rotate spool and sleeve assembly slowly when
removing from housing.
16. Push pin from spool and sleeve assembly.
Figure 41
Groundsmaster
®
455-D Page 4 - 53 Repairs
Hydraulic System