21. Rotate spool and sleeve assembly until pin is paral-
lel with port face. Install drive, make sure you engage
drive with pin, To assure proper alignment, mark drive
as shown (ref. B). Note relationship between slotted end
of drive to splined end of drive when marking.
Figure 53
22. Install 3" diameter seal in meter.
Figure 54
23. With seal side of meter toward spacer plate, align
star valleys (ref. A) on drive (ref. B). Note the parallel
relationship of reference lines A, B, C, and D. Align bolt
holes without disengaging meter from drive.
Figure 55
Groundsmaster
®
455-D Page 4 - 59 Repairs
Hydraulic System
To Next Page
Loading...
