GROUNDSMASTER® 455-D Maintenance Schedule
Minimum Recommended Maintenance Intervals:
Maintenance Procedure Maintenance Interval & Service Type:
Every
Every
Every
Every
800hrs
Inspect Air Filter, Dust Cup, and Baffle Every
400hrs
200hrs
100hrs
Lubricate All Grease Fittings
50hrs
A Level
Check Cutting Unit Gear Box Oil Level
Service
‡ Change Engine Oil and Filter
Check Battery Level and Connections
B Level
Inspect Cooling System Hoses
Service
Service Air Cleaner Filter Element
† Inspect PTO and Cutting Unit Belts
‡ Check Electric Deck Clutches Adjustment
‡ Check Electric PTO Clutch Adjustment C Level
† Torque Wheel Lug Nuts
Service
Replace Fuel Filter
Check Front Transaxle Oil level
Check Rear Axle Oil level (4wd)
Inspect Fuel Lines and Connections D Level
‡ Check Engine RPM (idle and full throttle)
Service
† Inspect Engine Fan Belt
Inspect Engine Timing Belt (see note below)
Drain and Clean Fuel Tank
Change Hydraulic Oil
‡ Replace Hydraulic Oil Filter
Change Front Transaxle Oil
Pack Rear Axle Bearings (2wd)
Change Rear Axle Oil (4wd)
E Level
Check Rear Wheel Toe-in
Service
† Initial break in at 10 hours
‡ Initial break in at 50 hours
Replace Moving Hydraulic Hoses
Replace Safety Switches
Annual Recommendations:
Items listed are recommended every 1500 hours or
Cooling System - Flush/Replace Fluid
2 years whichever occurs first.
Replace PTO Belts/Cutter Deck Belts
See Operator's and Service Manual for specifications and procedures)
NOTE:
Replace Timing Belt if worn, cracked or oil soaked. A new Timing Belt should be installed
any time the Belt is removed or loosened.
To Next Page
Loading...
