Toro groundsmaster 455-D - Operator Station Controls; Seat, Traction Pedal, Axle Shift, and Brake Controls

To Next Page

To Previous Page

_______________________________

______________________________ ______________________________

______________________________ ______________________________ _________________________________

_________________________________

______________________________ _________________________________

GROUNDSMASTER® 455-D Supervisor Maintenance Work Order Date:______________

(duplicate this page for routine use)

Unit Designation: TORO I.D. #: Remarks:

____________-____________

Service to perform (circle):

A B C D E Other

Technician:

A -Service (every 50 hours) B -Service (every 100 hours) C -Service (every 200 hours)

Inspect Air Filter, Dust Cup, & Baffle

Lubricate All Grease Fittings Check Battery Level and Connections Inspect PTO and Cutting Unit Belts

Check Cutting Unit Gear Box Oil Inspect Cooling System Hoses

A-Service required

Torque Wheel Lug Nuts

A and B Service required

D -Service (every 400 hours) E -Service (every 800 hours) Other

Inspect Engine Fan Belt Replace Moving Hoses

Inspect Engine Timing Belt Replace Safety Switches

Check Rear Axle Oil level (4wd) Drain and Clean Fuel Tank Coolant System - Flush/Replace Fluid

Inspect Fuel Lines and Connections Replace PTO/ Cutter Deck Belts

Change Front Transaxle Oil

A, B, and C Service required

Check Rear Wheel Toe-in

A, B, C, and D Service required

Hours:

Change Engine Oil and Filter Service Air Cleaner Filter Element

Check Electric Deck Clutches Adjustment

Check Electric PTO Clutch Adjustment

- Annual Service and Specials

Replace Fuel Filter

Check Front Transaxle Oil level

Change Hydraulic Oil & Filter

Check Engine RPM (Idle/Full Throttle)

Pack Rear Axle Bearings (2WD)

Change Rear Axle Oil (4WD)

(See Operator's and Service Manual for specifications and procedures) Form No. 95-851-SL

Other manuals for Toro groundsmaster 455-D