Toro Lawn-boy - Cleaning the Exhaust System (Snowthrower); Reassembling Exhaust System (Mower Only)

MAINTENANCE
16
Cleaning the Exhaust System
(Snowthrower)
1. Remove the muffler (see Fi
g
ure 10.) Clean as
needed.
Figure 10
0893-012
2. Inspect exhaust port (see Fi
g
ure 11). If cleanin
g
is
necessary, rotate piston to cover exhaust port, and
scrape carbon from exhaust port area. Use wood
only to clean this area.
Figure 11
0893-035
3. Install the muffler and torque the bolts per
specifications.
Reassembling Exhaust System
(Mower Only)
1. Install the exhaust pipe into the en
g
ine base (see
Fi
g
ure 12).
Figure 12
16547-006
2. The cover on the exhaust portion of the en
g
ine
base uses a hi
g
h temperature silicone to seal the
joint. Apply a coat of Loctite 598 or equivalent to
the sealin
g
surfaces before assembly. Torque the
four screws per specifications.
3. Re-install the blade and mulch fan, if removed.
Ti
g
hten the nut per specifications.