49
PIVOTING ZONE START BRAKE
Assembly
1. If the brake mountin
plate was not removed from
the en
ine, simply reconnect the
roundin
lead to
the push-on terminal directly above the
round
strap stop (4) and continue with the reassembly
process.
Note: If the brake mountin
plate was removed,
ti
hten screw (9) to 60 - 70 in. lbs. (6.78 - 7.91
Nm).
2. Secure the replacement brake plate to the en
ine
with shoulder screw (7). Ti
hten it to 90 in. lbs.
(9.2 Nm). Ensure that the brake plate pivots freely.
3. Slide the cable into the narrow slot on the brake
mountin
plate, and then push the cable into the
hole makin
sure the tabs lock into the bracket.
4. One end of the compression sprin
has a hook
shape to it; that end hooks over an indentation in
the brake plate. Squeeze the compression sprin
(A) and slip it over the cable between the brake
mountin
plate and brake plate. (See Fi
ure 90).
Fi
ure 90
0893-051a
5. Insert the leaded ball end of the cable into the
vertical slot (B) of the brake plate. (See Fi
ure 90.)
6. Operate the blade control bail to verify that the
brake mechanism stops within three (3) seconds.
There is no adjustment needed after this assembly
process is completed. (See Fi
ure 91).
Fi
ure 91
0891-1
A
B
To Next Page
Loading...
