REWIND STARTER
38
2. Tie a sin
le knot in the end of the rope; then sin
e
the end with a li
hter to prevent the knotted end of
the rope from frayin
(see Fi
ure 62). Tie a simple
knot in the rope to prevent too much from retractin
until the starter handle is installed.
Figure 62
lbv0043d.bmp
3. Reassemble the starter and shroud with the four
screws and nuts. Remember the orientation of the
rope outlet.
4. The shroud must be assembled by slippin
the
shroud over the two studs on the cylinder head
then rotatin
the shroud down until the holes on the
en
ine block and shroud ali
n. Install the nuts on
the studs and two screws on the side opposite the
head. Note: Do not overti
hten. (See Fi
ure 63.)
Figure 63
0720-002
To Next Page
Loading...
