a
751.1.0490.18
4.
Remove the throttle cable screw and nut
from the throttle cable mounting bracket.
5.
Detach the carburetor from the engine by
removing the
two
mounting screws. Discard
the
two
smaller carburetor gaskets on either
side of the carburetor shield. Keep the heat
shield/primer bulb bracket for later
installation.
6.
Disconnect the fuel line and the primer tube
from the carburetor fittings.
7
Pull the carburetor assembly down and
away from the engine
so
the air vane
governor clears the hole in the shroud
mounting base.
Service Section
5-7
To Next Page
Loading...
