SERVICING
(cont’d)
Disassembly (cont’d)
8.
Remove the brass inlet fuel valve seat and
9.
Remove the nozzle and the high speed jet
discard.
from the nozzle.
Cleaning and Inspection
1.
With the carburetor completely
disassembled, thoroughly clean all parts; do
not soak the parts, use an aerosol
carburetor cleaner. Inspect for wear or
deterioration. Blow dry all carburetor
passages with compressed air.
CAUTION:
If
a tag wire is used, never
enlarge or restrict any passageway in the
carburetor.
2.
Always check the carburetor mounting
flange and fuel bowl mounting flange
surfaces to be sure they are flush.
Assembly
Tools
Required
Flat blade screwdriver
Needle nose pliers
1.
Install the high speed jet into the fuel nozzle.
2.
Turn the carburetor over and install the
nozzle assembly into the carburetor body.
3.
Install a new brass inlet fuel valve seat.
5-10
Service Section
To Next Page
Loading...
