751.I.0490.34
751.1.0490.34A
6.
Replace the core plugs
if
leaking, using
Screw Lock on the outside surfaces.
CAUTION:
Do
not attempt to clean any
with a drill bit.
hole
REED VALVE SERVICE
Tools
&
Supplies Required:
Loctite 271
Carburetor Solvent
Feeler Gauge
These assemblies permit fuel mixtures to enter the
crankcase on the compression stroke and to trap
fuel mixture in the crankcase on power strokes.
Check the clearance between the tip of the
reed and the plate; replace the reeds if the
clearance is more than
.004"
(.l mm).
Clean the reeds carefully, by hand, using
carburetor solvent
CAUTION:
Do
not
use
compressed
air
to
clean
the
reeds.
High
pressure will
cause distortion.
When replacing the reeds, install with the
smooth edge down and use Loctite 271 on
the thread of the screws.
Service Section
9-13
To Next Page
Loading...
