CD
PACK
(cont'd)
Air Gap Adjustment
Tools
required:
Air Gap Gauge (p/n 604659)
10
mm Socket
1.
Rotate the flywheel until the magnets are
directly adjacent to the
CD
Pack as shown.
2.
Adjust the air gap by loosening the screws,
inserting the gauge or a piece
of
.010"
(.254 mm) shim stock, and tightening the
screws.
Removal/Installation
Tools Required
1Omm
Socket
Flat blade screwdriver
1.
Disconnect leads and remove the mounting
screws.
2.
Remove the screws, replace the
CD
Pack
and set the gap as outlined in the previous
topic. Torque the screws to
100
in. Ibs
(11
Nm).
FLYWHEEL
The flywheel is connected directly to the
crankshaft (secured by a key and nut) and turns
at the same speed as the crankshaft. Two
permanent magnets, imbedded in the flywheel,
rotate past the coil in the
CD
Pack to begin the
generation of electricity.
Imbedded in the opposite side of the flywheel
are steel counter weights which offset the weight
of
the magnets. These counter weights are not
magnetic.
.1.1207.10
7-6
Service Section
To Next Page
Loading...
