Toro V - Engine Inspection, Repair, and Reed Valve Service

r
2. Remove the entire crankshaft assembly and
discard the oil seals.
Carefully remove the
HSH (hex socket
head) cap screws
to remove the connecting
rod cap and the split bearing liner. The 32
needle roller bearings are under the split
bearing liner and will be loose. Careful
account for all of them.
3. Remove the piston and rod assembly;
separate the assembly,
if necessary, using
a compression pliers on the retaining ring.
Use the wrist pin knockout tool to punch out
the wrist pin.
INSPECTION AND REPAIR
9
Tools Required:
Gel Seal and Gasket Remover
Screw Lock (p/n
682301)
1. Check bearings for wear and freedom of
movement; replace
if questionable.
Service Section 9-11