REASSEMBLY
Tools
&
Supplies Required
Loctite 271
Loctite 515 Gasket Maker
Piston Stop (p/n 677389)
Ring Compressor (p/n 609967)
Seal Driver (p/n 608976)
1. Secure the wrist pin using the snap ring.
Make sure the square edge of the snap ring
faces out and the ring opening faces up
(toward the top
of
the piston).
2.
Install the pressure back piston ring in the
top groove with the bevel facing up; The
square cut ring goes second and has no
top or bottom orientation. Stagger the ring
gaps.
CAUTION:
Use the piston stop to prevent the
piston from traveling too far up into the cylinder.
If
the piston goes to far into the cylinder the only
way to remove it from the cylinder is
to
break the
piston.
3. Assemble the rod cap. Ensure that the
dovetail ends of the liner are matched.
Install new needles (pin 683911).
NOTE: One side of the paper is sticky;
remove the paper carefully while installing
the needle bearings. There should be
32
needle bearings on the lower connecting
rod.
9-14
Service Section
To Next Page
Loading...
