SERVICING (cont’d)
Removal (cont’d)
8.
CAUTION:
Avoid damaging the delicate
governor spring during this step.
Slide the white plastic control lever to either
end
of
its adjustment and snap it to the
locked position. This will help restrict its
movement while you disconnect the throttle
cable from the control lever.
Disassembly
Tools Required:
Needle Nose Pliers
Flat blade screwdriver
1.
At the throat
of
the carburetor, use the
needle nose pliers to gently pull the throttle
plate out of the air vane governor assembly
shaft. Notice the orientation of the small
protrusions on the throttle plate as you pull
it out. The single protrusion should be on
your left (next to the hole at the
9
o’clock
position).
2.
Remove the retainer holding the speed
control lever.
751.I.0490.3
5-8
Service Section
To Next Page
Loading...
