751.I.0490.2!
The two-cycle engine is always well lubricated as
long as the correct gas/oil mixture(using proper 2
cycle oil) is maintained in the fuel tank. Oil
suspended in the fuel vapor adheres to all moving
parts, keeping them continually coated, regardless
of operating angle.
SERVICE
TIPS
Cylinder/Crankcase Halves
The
two
halves are a matched pair and cannot be
mixed. Check the cleaning and assembly
procedures under Engine -Disassembly (pg 9-11) in
this section.
Be sure to use Loctite
515
gasket maker on the
cover only. Do not apply gasket maker to either
crankshaft seal. Torque the
4
washer-head screws
that secure the two halves to 105-115 in. Ibs (12
13
Nm).
Oil
Seals
Visually inspect for leaking or damaged
oil
seals
(two locations).
Service
Section
9-5
To Next Page
Loading...
