DISASSEMBLY
(cont’d)
/7
4.
Remove the 10 mm shoulder screw to
remove the brake plate and brake pad
attached to
it.
assembly requires replacement, remove
second screw to remove the brake
mounting plate from the engine.
5.
If the ground strap or any part
of
this
ASSEMBLY
Tools Required
10mm
Sockets
Needle
nose
Pliers
removed from the engine, simply reconnect
the grounding lead to the push-on terminal
directly above the ground strap stop and
continue with the reassembly process.
NOTE:
If the brake mounting plate was
removed, torque the screw to 60 70 in. Ibs
(6.78 -7.91 Nm).
1.
If
the brake mounting plate was not
2.
Secure the replacement brake plate to the
engine with the shoulder screw. Torque
it
to
90 in Ibs (9.2 Nm). Ensure that the brake
plate pivots freely.
(shroud removed for
photo
only)
the
10-6
Service Section
._
To Next Page
Loading...
