7-9Z Master Z400 Service Manual
7
5. Install the front and rear lift chains to the mower
deck (Fig. 435).
Fig 435 PICT-0305
Fig 437 g.49G001678
8. Route the belt around the spindles, idler pulleys and
the PTO clutch (Fig. 437).
Fig 436 PICT-0313
6. Raise the deck to the transport position. Remove the
4x4 wood blocks.
7. Set the lift handle at the 3” (7.6cm) height-of-cut
position. Pin in place (Fig. 436).
MOWER DECKS/PTO
1. Fixed idler arm 4. Mower belt
2. Square hole 5. Belt guide
3. Fixed idler pulley 6. Spring-loaded idler
pulley
To Next Page
Loading...