Toro Z Master Z400 Series - Motion Control Assembly Installation

3-33Z Master Z400 Service Manual
3
Fig 145 PICT-0078
6. Disconnect neutral switch wire harness from the
neutral switch (Fig. 145).
CHASSIS
7. Remove the two bolts and nuts that retain ange
bearing on the inside of the motion control (Fig.
146).
Fig 146 PICT-0079
8. Remove the two bolts and nuts that retain the ange
bearing on the outside of the motion control (Fig.
147).
Fig 147 PICT-0080
Motion Control Assembly Installation
Reverse the order of removal.
Fig 148 PICT-0081
9. Remove the motion control assembly from the frame
(Fig. 148).