3-14 Z Master Z400 Service Manual
3
CHASSIS
7. Remove both taper cone bearings (Fig. 079).
Fig 079 PICT-0224 rev
Fig 080 PICT-0225 rev
Caster Fork Wheel and Tire Assembly (Fig. 080).
Fig 081 PICT-0227
10. Pack both tapered wheel bearings. Reassemble per
Fig. 000 (above).
Note: The axle bolt torque sets the pre-load on the
front caster wheel bearings. Tighten the axle
bolt to set the bearings then back off 1/4 turn.
Pump grease into the wheel bearings through the
grease tting located on the rim (Fig. 081).
Fuel Tank Removal
1. Disconnect the negative battery cable from the
battery. Drain the fuel tank.
Left Side Fuel Tank Removal
A B C C B A
G
D
E
A. Seal Guard E. Axle Bolt
B. Caster Seal F. Axle Bolt Nut
C. Taper Cone Bearing G. Wheel & Tire Assembly
D. Caster Axle
F
To Next Page
Loading...