3-19Z Master Z400 Service Manual
3
6. Remove the E-ring from the outer end of the parking
brake shaft (Fig. 096).
Fig 096 PICT-0038
7. Remove the cotter pin and clevis pin holding the
brake rod assembly to the parking brake shaft (Fig.
097).
Fig 097 PICT-0039
Fig 099 PICT-0041
9. Inspect the brake shaft and bushings for excessive
wear. Replace any worn or broken components
(Fig. 099).
Fig 098 PICT-0040 rev
8. Slide the parking brake shaft assembly out of the
frame (Fig. 098).
CHASSIS
CA
A
B
D
E
F
A. Side Flange Bearings D. Clevis pin
B. Brake Shaft E. Cotter pin
C. Brake Lever F. E-Ring
To Next Page
Loading...