Toshiba 2000 V Series - Page 87

6F8C0845
65
4.2 S Controller Interface Buffer Memory Configuration
4
(13)Input/output data setting information (010BH to 028AH: 384 words)
Indicates to which part of the input/output data area is allocated the input/output data
of each slave device (node address: NA). The input/output data setting information
has 6 words per slave device.
Figure 4-12 shows the top addresses in the areas where information on each node is
stored. Table 4-10 shows the meanings of each slave device.
Data is entered in these areas when the DN611 is set to run mode (transmission
enabled) by an operation mode control request after the slave device parameters are
set. "0" is set in areas where no slave device exists.
Figure 4-12 Input/Output Data Setting Information Addresses
010BH NA=0 018FH NA=22 0213H NA=44
0111H NA=1 0195H NA=23 0219H NA=45
0117H NA=2 019BH NA=24 021FH NA=46
011DH NA=3 01A1H NA=25 0225H NA=47
0123H NA=4 01A7H NA=26 022BH NA=48
0129H NA=5 01ADH NA=27 0231H NA=49
012FH NA=6 01B3H NA=28 0237H NA=50
0135H NA=7 01B9H NA=29 023DH NA=51
013BH NA=8 01BFH NA=30 0243H NA=52
0141H NA=9 01C5H NA=31 0249H NA=53
0147H NA=10 01CBH NA=32 024FH NA=54
014DH NA=11 01D1H NA=33 0255H NA=55
0153H NA=12 01D7H NA=34 025BH NA=56
0159H NA=13 01DDH NA=35 0261H NA=57
015FH NA=14 01E3H NA=36 0267H NA=58
0165H NA=15 01E9H NA=37 026DH NA=59
016BH NA=16 01EFH NA=38 0273H NA=60
0171H NA=17 01F5H NA=39 0279H NA=61
0177H NA=18 01FBH NA=40 027FH NA=62
017DH NA=19 0201H NA=41 0285H NA=63
0183H NA=20 0207H NA=42
0189H NA=21 020DH NA=43