16
Getting started
Turning on the TV
Switching On
If the RED Standby LED is unlit, check that the plug is
connected to the power supply. If the picture does not
appear press
on the remote control, it may take a few
moments.
To put the television into Standby press
on the remote
control. To view the television press
again. The picture
may take a few seconds to appear.
For energy saving:
We recommend that you use the television with factory
settings. These settings are designed for energy saving.
Unplugging the mains plug will reduce energy use to
zero. This is recommended when the television is not
being used for long periods, e.g. when on holiday.
Reducing the brightness of the screen will reduce energy
use. Energy efficiency reduces energy consumption and
can save money by reducing electricity bills.
Note: If you skip this step, the channel scan can still be
performed later in the Setup Menu.
Quick Setup
Before switching on the TV, put your decoder and media
recorder to Standby if they are connected and ensure the
antenna is connected. To setup the TV, use the buttons
on the remote control. (
page 14 Learning about the
remote control)
1. For first time use, plug in the television and press
the
button.
The Quick Setup screen will appear at the first use.
Note: This function is accessed in the SETUP
¼
Quick
Setup menu.
2. Language and then press
Select
OK
Tuner Mode
RETURN
Back
Quick Setup
Language
Digital Subtitle Language
Digital Subtitle Language 2nd
Audio Language
Audio Language 2nd
English
English
French
English
French
3. Digital Subtitle Language,
Digital Subtitle Language 2nd, Audio Language
and Audio Language 2nd
select your preferred language.
4.
Select
OK
Tune Mode
RETURN
Back
Time Zone
This function allows you to manually
set the time zone.
New South Wales
Press to select Location.
5. Home or Store. For normal
home use, select Home.
Select
OK
Auto tuning
RETURN
Back
Location
To use the TV for the display in a store showroom,
please select [Store].
[Home] mode is recommended for normal use.
Home
When Store is selected, the confirmation window
appears.
Select
OK
Auto tuning
RETURN
Back
Location
You have selected [Store].
This mode consumes more energy.
Are you sure you want to set to this mode?
NO
YES or NO.
6. Press
to enter the Auto tuning menu.
Note: Please make sure the aerial is connected to the
TV before tuning.
RETURN
Back
Auto tuning
Tuning Mode
Start Scan
DTV
OK
Edit
ATV, DTV or ATV and DTV.
Start Scan and press
.
Auto tuning (DTV)
6 %
Channel: 33
0
Progress Found
EXIT
Stop
The search will begin for all available stations. The slide
bar will move along the line as the search progresses.
You must allow the television to complete the search.
When the search is complete the television will
automatically select channel 1. This may not be a clear
picture or the signal may be weak, so the station order
can be changed using ATV/DTV Manual Tuning in the
SETUP menu.
To Next Page
Loading...
