Toshiba 51H94 - Connecting a DVD Player with Co; (Component Video) Ajld a VCR

A ÷ L
Connectinga DVDplayerwith ColorStmam(componentvideo)anda VCR
Your TV has Co[orStrearn _*(component video) inputs.
Com_ecdng a DVD player with cornponer_t video outpuE (such
as a Toshiba DVD player with Co[orStrearn '_) can grea@
enhance picture qua[it T,
You will need:
_' two coaxial cables
_, two sets of standard A/V cables
• Forbettel pit'tul_ petforrnance, ifyoul VCRhas S video, _se an
S videocable(pills theauclk_cat)los)insteadoflhe smndam'
videocable Howeve/;donot cof?f?ectbotb i)/f.)e_ of vkJeocnb/eto
VIDEO1 (of VIDEO2) at tbe sametime or thepicture
peffomTancewillbe unaccept_bh
• ffyou havea mono VCR,coffflectUMONO on/7?e71/
(VIDEO 0 toyour VC)R_aud/boutjack usingtile whM audio
cableonly
_' one pair of standard audio cables
_, one see of component video cables
• X)u canconnectthe componellt videocnb/es(i)lussun)k)
cables)from the DVDp/aye/to eithersetOfCO/OfStI_RIT?
]3*C/(S Of7 the ]]/(HD 1of HD 2) ',rileO<)bfStl_alT]HD- Zand
HD 2jacks cnnbeused withPmgf_ssl_ (480p. 720p) and
//tteflnced(_80/: 10800scansystem&A 708d s/qnd will
pfovk/ethebestp/ctuleperformance
• ffyr)urDVDp/ayerdoesnotl)avecomponentv/deo, see
page 1Uff J/otJrDVDpl_/ hasHDMI vkJeo,seepnde Z,9
To view antenna or Cable channels:
Turn OFF the VCR, Select the ANT 1 xideo input
source on the TV.*
TOview the DVD player=
Turn ON the DVD player. Sdect the Co[orStream HD-!
video input source on the TV.*
To view the VCR:
Turn ON d_eVCR. Select d_eVIDEO 1 video input
source on the TV.*
D
•Turn ON the VCR. Select the ANT 1video input source.*
Ttme the TV to channd 3 or 4 (whichever channd is
vacant in your area).
To record a TV program while watching a DVD:
Turn ON the VCR, Tune the VCR to the charmel to
record. Select d_e Co[orStream HD-! video input source
on the TV* to view the DVD.
Fromantennaor Cable
Stereo VCR
DVDpmayerwith componentvideo
Note: _?e VIDEO/AUDIO OUTj)cks output the signal8 _rom the
ANT I, ANT2, VIDEO L VIDEO 2, of VIDEO 3j?_cks wbe/_ tbe
appropm?_teinput mode/s selected
To use the TV Guide On Screen recording features:
1. Connect d_eG-LINK cable according to dae instructions
on page 25.
2. Make sure the VCR is connected to the A/V OUT jacks
on the TV (seeillustration).
3. Se_the VCR to the appropriate line inpu_ (refbr to your
VCR owner's manual fbr details), and then turn OFF the
VCR.
4. See Chapter 5 for details on setting up the TV Guide
On Screen system.
5. See Chapter 7 fbr de_ailson using the TV Guide
On Screen system.
÷
* lb select the video input source, press [N PUT on the remote control
(see page 67). lb program the TV remote control to operate other
devices, see Chapter 3,
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs,and other reateriMs is prNfibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and crireina_ liability.
H94(E)012-25(2B-Cnct)
17
Copyright @ 2004 TOSHIBA CORPOFtAT[ON, All dghts reserved,
÷
8/3/04, 3:41 PM
17
[